|
DCP_0126
Heater removed. FI harness will pass through the firewall to the right (driver's side) of the heater hole, coming in behind the curve in the heater duct.
Date: 02/18/2012
Views: 5577
|
DCP_0127
Pilot hole for the air nibbler
Date: 02/18/2012
Views: 2442
|
DCP_0128
Nibbled hole roughly 2"x2"
Date: 02/18/2012
Views: 2515
|
|
DCP_0148
Two lengths of 1/2"x1/8" flat strap were cut about 4" long and drilled with 1/4" holes on either end.
Date: 02/19/2012
Views: 2493
|
DCP_0156
4 holes drilled to 1/4", then to 3/8" and then nut-serts installed.
Date: 02/18/2012
Views: 2627
|
DCP_0157
4 holes drilled to 1/4", then to 3/8" and then nut-serts installed.
Date: 02/18/2012
Views: 2657
|
|
DCP_0158
Strap set in place. The factory connector will press against the firewall from the engine bay side, the flat strap will be used to tension it.
Date: 02/18/2012
Views: 2588
|
DCP_0159
Strap set in place. The factory connector will press against the firewall from the engine bay side, the flat strap will be used to tension it.
Date: 02/18/2012
Views: 2123
|
DCP_0160
4 nut-serts installed.
Date: 02/18/2012
Views: 2029
|
