"Raised" shifter boot area - far from perfection, but functional
"Raised" shifter boot area - far from perfection, but functional
Date: 12/31/1969
Views: 5200
|
Shifter was notched in one place with a grinder until I cut enough and got it hot enough to finish bending, then re-welded. This
Shifter was notched in one place with a grinder until I cut enough and got it hot enough to finish bending, then re-welded. This is in 1st gear
Date: 12/31/1969
Views: 1735
|
Reverse
Reverse
Date: 12/31/1969
Views: 7326
|
2nd gear
2nd gear
Date: 12/31/1969
Views: 761
|
5th gear
5th gear
Date: 12/31/1969
Views: 725
|
Clearance hole for the slave cylinder is still unfinished
Clearance hole for the slave cylinder is still unfinished
Date: 12/31/1969
Views: 1334
|
Looking forward after lowering the transmission mount
Looking forward after lowering the transmission mount
Date: 12/31/1969
Views: 1064
|
PTO clearance
PTO clearance
Date: 12/31/1969
Views: 1325
|
More PTO clearance
More PTO clearance
Date: 12/31/1969
Views: 1418
|
Driveshaft to floor clearance
Driveshaft to floor clearance
Date: 12/31/1969
Views: 726
|
Driveshaft to floor clearance - note the rub mark on the driveshaft from just 10 miles.
Driveshaft to floor clearance - note the rub mark on the driveshaft from just 10 miles.
Date: 12/31/1969
Views: 795
|
DCarrier bearing view
DCarrier bearing view
Date: 12/31/1969
Views: 695
|
DCP_0007.JPG
DCP_0007.JPG
Date: 12/31/1969
Views: 1017
|
Rear dump headers, driver's side
Rear dump headers, driver's side
Date: 12/31/1969
Views: 738
|
IFS front suspension, looking forward from under the truck
IFS front suspension, looking forward from under the truck
Date: 12/31/1969
Views: 1728
|
Looking to the rear, starting at approximately the carrier bearing crossmember. Passenger muffler cut off and mid-replacement
Looking to the rear, starting at approximately the carrier bearing crossmember. Passenger muffler cut off and mid-replacement
Date: 12/31/1969
Views: 977
|
Starter, with starter wire re-routed UNDER the frame and outboard
Starter, with starter wire re-routed UNDER the frame and outboard
Date: 12/31/1969
Views: 1479
|
Another look at the header
Another look at the header
Date: 12/31/1969
Views: 1698
|
2012-09-26_19-55-15_181.jpg
Date: 09/26/2012
Views: 1570
|
|