|
DCP_4197
Ground rivets for the box-mount that needs removed
Date: 05/19/2008
Views: 1071
|
DCP_4198
Box mount removed
Date: 05/19/2008
Views: 715
|
DCP_4199
Plasma'd the old bolts out of the pin box. Then a hammer and punch. Plasma is a Hypertherm 600.
Date: 05/19/2008
Views: 1136
|
DCP_4200
I needed to move the gooseneck trailer closer to the shop to install a rear receiver on it, but didn't have the gooseneck hitch installed yet..
Date: 05/19/2008
Views: 1070
|
DCP_4201
.. so I made due with what I had.
Date: 05/19/2008
Views: 953
|
|
DCP_4202
Date: 05/19/2008
Views: 1000
|
DCP_4203
Date: 05/19/2008
Views: 996
|
DCP_4204
Long combination.. 20' Travelette, 20' deck on the goose..
Date: 05/19/2008
Views: 779
|
DCP_4205
Date: 05/19/2008
Views: 966
|
DCP_4206
Backed up to the shop and within range of the plasma and welder.
Date: 05/19/2008
Views: 1108
|
|
DCP_4207
Date: 05/19/2008
Views: 973
|
DCP_4208
Looking forward at the tongue / hitch
Date: 05/19/2008
Views: 948
|
DCP_4209
Date: 05/19/2008
Views: 720
|
DCP_4210
Date: 05/19/2008
Views: 683
|
DCP_4211
First attempt at narrowing the hitch - 1.5" inboard on either side.
Date: 05/18/2008
Views: 929
|
|
DCP_4212
First attempt at narrowing the hitch - 1.5" inboard on either side.
Date: 05/18/2008
Views: 949
|
DCP_4213
First attempt at narrowing the hitch - 1.5" inboard on either side, both sides clamped in place.
Date: 05/18/2008
Views: 701
|
DCP_4214
Date: 05/18/2008
Views: 701
|
DCP_4215
The pin-box will need to be cut down - I have it installed upside down right now so the cutting can come later, but clearly it's going to hit on the S-bend.
Date: 05/18/2008
Views: 885
|
DCP_4216
Date: 05/18/2008
Views: 627
|
|
DCP_4217
Test fit on a spare section of 1974 pickup frame. Pin box is installed upside down and under-neath instead of on top.
Date: 05/18/2008
Views: 1029
|
DCP_4218
Still too wide - the Z-plates hover a bit too much over the top of the frame.
Date: 05/18/2008
Views: 682
|
DCP_4219
Still too wide - the Z-plates hover a bit too much over the top of the frame.
Date: 05/18/2008
Views: 1071
|
DCP_4220
Another scribe line to move it in another 1/2" or so per side.
Date: 05/18/2008
Views: 934
|
DCP_4221
Another scribe line to move it in another 1/2" or so per side.
Date: 05/18/2008
Views: 927
|
