|
Holes must be identified and transferred to the aluminum
Date: 05/12/2016
Views: 1246
|
Adapting the plate to the motor
Date: 05/12/2016
Views: 1345
|
Motor plate progress
Date: 05/15/2016
Views: 1273
|
ME1004 with adapter plate for the frame, pulley, and a plastic spacer becuase the ME1004 shaft is shorter
Date: 05/15/2016
Views: 2685
|
Some 3/8" header bolts were used rather than relieve the mower frame - some of the bolt heads were too close to the gas hol
Date: 05/15/2016
Views: 1132
|
|
3/8 header bolts used in a few spots
Date: 05/15/2016
Views: 1313
|
Building a battery hold-down for the Volt pack
Date: 05/18/2016
Views: 1007
|
Some steel rod across, some 1x1 square tube to make a right-angle adapter. 1/4" allthread will finish the job
Date: 05/18/2016
Views: 1155
|
Paint for the battery hold down
Date: 05/18/2016
Views: 1186
|
Painting the tie-downs. Plus you see the seat-safety-switch that was adapted to a 48v safety switch
Date: 05/18/2016
Views: 1136
|
|
Battery mounted, motor mounted
Date: 05/22/2016
Views: 1141
|
ME1004 and Volt battery in place
Date: 05/22/2016
Views: 1025
|
48V key switch adapted
Date: 05/22/2016
Views: 1004
|
Ready to run
Date: 05/23/2016
Views: 948
|
Wiring the BMS - charge/balance only, not a discharge BMS
Date: 05/25/2016
Views: 1125
|
|
Soldering
Date: 05/25/2016
Views: 1054
|
Soldering the stock Chevy Volt BMS pigtail to the BMS
Date: 05/25/2016
Views: 1176
|
BMS wiring
Date: 05/25/2016
Views: 1143
|
BMS mounted (zip-ties) to the battery
Date: 05/26/2016
Views: 1575
|
BMS mounted to battery
Date: 05/26/2016
Views: 1568
|
|
BMS mounted to the battery
Date: 05/26/2016
Views: 1603
|
Hood hung, too
Date: 05/27/2016
Views: 1555
|
Outside
Date: 05/27/2016
Views: 2654
|
Battery, motor, some wires..
Date: 05/27/2016
Views: 1640
|
Mower outside
Date: 05/30/2016
Views: 3001
|
